Here is the example for R1 for both Step 14 and 15. Step 15: Configure RIPv2 routing for the GigabitEthernet and the PC-1 to PC-2? Show screenshot and explain why or why Question 5 (1 point): Can you successfully ping from Step 13: Using ping insure connectivity to the connected Step 12: Insure all interfaces are not administrativelyĪpply “no shutdown” for each interface and then use “show Question 4 (2 point2): What is DCE and what is On R1, R2, and R3 to check which interface is DCE and which one is Tips: use “show controller S0/1/0” and “show controller S0/1/1” Here is the example for interface S0/1/0. Step 11: Configure R2 interface Serial0/1/0 and Serial0/1/1 asĭCE to provide clocking to R1 and R3 at a clock speed of 2 Mbps. Same process for R1 Loopback interface 101, and R3 Loopback Here is the example for R1 Loopback interface 100. Step 10: Assign IP address and subnet to loopback of R1 and
Step 9: Assign IP address and subnet to serial interfaces of R1, Step 8.2: Check the status by “show interface” command for all Step 8.1: Change the status from administratively down to Step 8: Insure GigabitEthernet interfaces are notĪdministratively down by access each interface and issue a “no
Step 7: Assign IP address, subnet, and default gateway toĬlick the PC icon, then choose desktop tab. To repeat the same process for R2 and R3. Step 6: Assign IP address and subnet to GigabitEthernet Repeat the same process for all routers (R2 and R3) and switches
Then, use the command “no ipĭomain-lookup” to disable the DNS lookup. First, you need to enter theĬonfigure terminal mode. Step 5: Configure no-domain lookup on all routers andĬlick R1, then choose the CLI tab.
Your topology should be the same as the following figure.
Step 1: Create three routers, three switches, and two PCs. Use Cisco IOS show and debug commands to verify and troubleshoot In this lab, we willĬonfigure a basic lab topology, enable RIPv2 on the routers andĬonfigure them to advertise their networks. This lab helps you gain a better understanding of how toĬonfigure and troubleshoot RIP version 2.
How RIP works? With RIP, a router sends its full routing table Despite this limitation, RIP works great for basic Infinite distance, in other words, the route is considered Loops by employing a limit on the number of hops permitted in a Which uses the hop count as a routing metric. RIP is one of the oldest distance-vector routing protocols,